NeckTech Sport with ClicLock - Stainless steel

Item number: 50050-55

Highlights

Qualitystainless steel
Feature1 ring
  • safe and easy to apply due to the ClicLock
  • quick and pinpoint influence

Please login to see the price!

A natural influence on the dog through the imitation of the dog’s fang teeth and therefore an incomplicated communication with the dog is offered by SPRENGER NeckTech Sport.

The collar facilitates a gentle education with harmony and confidence between dog and owner and provides a pleasant wearing comfort for all short and long-haired breeds.


Please be aware that there is a little impact on the influence due to differing fur length and thickness.

An accurate fit of the Neck-Tech Sport is recommended.
Open catalog page
More Information
Feature1 ring
Qualitystainless steel

Only chains and fittings made of stainless steel are recommended for use near the coast or under permanently extreme humid conditions.

The red slider on the old ClicLock version was only used for additional protection against unintentional opening. It is a plastic part, which is worn out by the regular movement. The functionality and quality of the ClicLock is not affected in any way.

Since the introduction of the new ClicLock model, an additional plastic slider, a so-called jacket, has been placed over the shutter release for additional protection.

The closing process of the ClicLock ends with a clearly hearable "click". This acoustic signal gives you the certainty that the ClicLock has locked properly.

The individual elements of the patented NECK TECH are punched from strip material and are available in different qualities, which can be individually combined with each other.

The NeckTech in combination with the ClicLock fastener is extremely durable and long-lasting.

While the NeckTech Fun is a pure necklace for guiding the dog, the NeckTech Sport is a chain with the possibility of punctual impact and is therefore a good and fancy alternative to the use of a standard training collar.

Individual elements are available in all different qualities and can easily be added or replaced to individualize the Neck-Tech collar!

Place the back of the Neck-Tech on a flat, clean surface.

  1. Insert a slotted screwdriver into the gap on the back of a single element.
  2. Bend the link gently open by turning the screwdriver as far as necessary to obtain a gap that allows a single element to be added or removed by clipping it in or out. Proceed cautiously and take care because too frequent and too massive levering can lead to material fatigue at this point.
  3. Finally, close the gap to the original level by using a combination pliers and squeezing gently.

 A soft cloth used as a base will prevent from causing scratches on the surface.

Share:

This website uses cookies. By using this site, you agree to the use of cookies. For details please refer to our privacy policy.
Do not show this message again